Operation of the Controller Using the Control Panel

 

Teach Mode

The controller may be used to learn and execute a motion profile without any programming.

To use the teach mode capability;

1) Select ‘Teach Mode’ option located on the lower left corner of the pane with the light red background.




2) Using the keypad located on the right hand side of the screen, and/or the joystick, and/or the trackball move the mechanism to different locations.


3)  Press the ‘Add’ button.  This will include the current point to the Position Log File that can be saved and retrieved.


4) The above steps may be repeated as many times as necessary.

5) After completion, save the information in the Position Log File by clicking on ‘File’ then ‘Save as’.  

 Position Entry Mode

The software allows the user to enter the position of the points to move to. 

To use the Position Entry Mode capability;

1) Select ‘Position Entry’ option located on the lower left corner of the pane with the light red background.


2) Enter the position information in each corresponding field then click on 'Add" button.  This will include the current point to the Position Log File that can be saved and retrieved.

4) The above steps may be repeated as many times as necessary.

The position information is saved in .csv (Comma Separated Value) format. It is possible to generate and edit a profile using a spread sheet or text editor. However, the file must be saved as .csv file.


 

 

 




Configuration Panel


Home | Products | Accessories | Knowledge Center | About Us | Terms of Use |Testimonials | Featured Products |Site Map | Videos | Contact Us