In this mode, the motion controller does not need an
external device such as a PC to operate. The
controller is programmed in a simple programming
language. The code is developed, downloaded to the
controller, run and saved in the controller's
non-volatile memory using the supplied Integrated
Development Environment (IDE) software.
In this mode, the external host such as a PC,
micro-motion controller or PLC sends a series of commands
to the motion controller via the RS-232 serial port. The
controller processes and performs the incoming
commands and responds with proper messages.
In this mode, the
is operated using an
analog joystick or a trackball.
The speed of the
proportional to the tilt angle of the joystick
or the rotational
speed of the trackball.