Solenoid Driver

Data Sheet
Wiring Diagram

Similar Solenoid Controller and Driver Products

Pick and Hold Module 
Proportional (PWM) Module
Closed Loop Solenoid Position Control Module
Pick and Drop Module
Load On-Off Power Cycling Module
Dual Proportional Valve Controller
Solenoid Control System
Related Products
USB Control Card
Power Supplies

 

Features

  • Low Cost

  • Small Size

  • Low Weight

  • High Efficiency

  • Microcomputer Based

  • Very High Reliability

  • Pulse Width Modulated (PWM)

  • Single Supply, from +5 VDC to +13.5 VDC

  • Output Current 3 Amps Peak, 1 Amps RMS
  • RoHS Compliant 

  • QUANTITIES AVAILABLE IN STOCK
 
Typical Applications
  • Solenoids

  • Valves

  • Relays

  • Actuators

  • Voice Coil Actuators

  • DC Motors

  • Hydraulics

  • Electromagnets

  • LEDs

General Specifications

  • Supply Voltage, +9 to +50 VDC

  • Peak Current, 50 Amp

  • Average Current, 4 Amp
 

The Load On-Off Cycling Module is designed to enable the user to cycle the voltage across a solenoid or other devices. The applied peak voltage, duty cycle and the frequency are adjusted using three onboard potentiometers.

There are three onboard adjustment potentiometers.

The first potentiometer adjusts the frequency of actuation. The range of the frequency is from 0.14 through 30 cycles per second. The second potentiometer adjusts the output voltage. The duty cycle of the actuation (ratio of on time to the length of one full cycle) may also be adjusted using the third potentiometer.

It is possible to run multiple modules using the designated master board signal generator.
This product is RoHS compliant.

Performance Specifications

Parameter

Min

Typical

Max

Units

Supply Voltage

5

 

13.5

VDC

Peak Current    

3

Amp

Average Current  

 

1

Amp

Operating Temperature 0   50 Deg C

 

Timing Diagram

 

Mechanical Specifications

Mounting Pattern Four 6-32 Screws, 0.15" Diameter (3.8 mm)
Dimensions 3.00” W, 3.00” D, 0.85” H (76.2 mm, 76.2 mm, 21.5 mm)

 

Ordering Information
 
Part No. Description Amount
SD-PH-01 Single-device High Performance Pick and Hold Solenoid Driver Module  
SD-PH-02 Two-device High Performance Pick and Hold Solenoid Driver Module  
SD-PWM-01 Single-device High Performance PWM Solenoid Driver Module, 0-5 VDC Input Signal  
SD-PWM-02 Two-device High Performance PWM Solenoid Driver Module, 0-5 VDC Input Signal  
SD-PDD-01 Single-device High Performance Pick and Drop Solenoid Driver Module  
SD-PDD-02 Two-device High Performance Pick and Drop Solenoid Driver Module  
SD-LOC-01 Single-device Load On-Off Cycling Module  
       

Home | Products | Accessories | Knowledge Center | About Us | Terms of Use |Testimonials | Featured Products |Site Map | Videos | Contact Us